Lacy Smile Card

By  Windy Robinson  for  Spellbinders

size: 5-1/8"

  • Lacy Smile Card


  • Bazzill Basics Paper OP White Cardstock
  • Want2Scrap Say it with bling Self-Adhesive White Pearls
  • Black satin ribbon, 5/8”-wide


  • Spellbinders Grand Calibur Die-Cutting System and Dies: Nestabilities Stately Circles (S4-388), Grand Nestabilities Grand Stately Circles (LF-019), Grand Nestabilities Grand Circles (LF-114), Shapeabilities Framed Tags One (S4-392)
  • Flourishes LLC Tag Lines Clear Stamp Set
  • Acrylic block
  • Large sponge daubers
  • Clearsnap ColorBox Ink Pads: Archival Wicked Black; Chalk Tangerine, Lime Pastel, and Berrylicious
  • Adhesives: transparent tape; clear dots; Scrapbook Adhesives by 3L E-Z Runner Permanent Adhesive, 3-D Foam Squares

Basic Supplies

  • paper trimmer, scoring tool, scissors, ruler, pencil, wax paper, transparent tape
  • 1. Make 6"x6" white top-fold card.
  • 2. Using small piece of transparent tape to prevent shifting, tape Grand Circles #2 die (4-3/4") to card, placing fold just inside cutting line of die template. Die cut/emboss card. Remove tape.
  • 3. Die cut/emboss following circles from white cardstock (see "tip"): Grand Stately Circles #1 (5-1/8"); Stately Circles #2 (2-1/4"), #3 (3"), and #4 (4"); Frame Tags One Circle Tag Insert.
  • 4. Using die template as stencil and sponge dauber, sponge center of each Stately Circles shape with different color of chalk ink; circle #2 is Berrylicious, #3 is Lime Pastel, and #4 is Tangerine. Let dry completely.
  • 5. To assemble card, use adhesive runner to apply adhesive around edges of card front. Center and adhere Grand Stately Circles die cut to card base.
  • 6. Center and adhere inked Stately Circles die cuts to card, from largest to smallest, using foam squares.
  • 7. With holes at left and right, stamp Wicked Black sentiment onto die-cut circle tag. Adhere tag to card with clear dot. Adhere pearls to tag over holes.
  • 8. Tie black ribbon bow and adhere to top of card with clear dot.
  • Tip
  • 1. Place wax paper between paper and die template for an easy release. After removing die-cut shape and wax paper from die template, place die cut back in template, turn over to smooth side, and stencil inside desired openings.