Beading / Jewelry

On the Cutting Edge: Die-Cut Pendant

By  Keri Lee Sereika 

size: 2" diameter

  • On the Cutting Edge: Die-Cut Pendant


  • Metallic cardstock: copper; coffee
  • Swarovski Elements beads (Swarovski): 6mm Sapphire bicones, four; 2mm Crystal bicones, two; 6mm Crystal Bronze Crystal Pearls, two
  • Antique Copper Large Textured Cable Chain (Nunn Design), 18"
  • Antique Copper findings (Nunn Design): headpins; jump rings; clasp


  • Premo! Sculpey Copper Oven Bake Clay (Polyform Products)
  • Acrylic Roller (Polyform Products)
  • Clay-dedicated tile
  • Americana Acrylic Paint (DecoArt): Baby Blue; Buttermilk
  • The Wizard die-cutting system and Nestabilities dies (Spellbinders Paper Arts): Lacey Circles Small; Classic Inverted Scalloped Circles Small
  • Impressabilities Fleur De Lis template (Spellbinders Paper Arts)
  • ColorBox Toffee Fluid Chalk Inkpad (Clearsnap)
  • Tools (Beadalon): Round-Nosed and Flat-Nosed Pliers; Wire Snips
  • Sanding block
  • Piercing tool
  • Oven
  • Zip Dry Paper Glue (Beacon Adhesives)
  • 1. Follow manufacturer's instructions to condition clay. Roll medium-sized ball, place on tile, and flatten slightly with acrylic roller.
  • 2. Die cut small Lacey Circle shape from coffee cardstock. Press die cut onto surface of clay; remove and poke small hole in top of disc. Follow manufacturer's instructions to bake and cure clay. Let cool completely.
  • 3. Die cut smaller inverted circle from copper cardstock. Emboss die cut with Fleur de Lis pattern, noting placement of pattern to achieve pleasing effect.
  • 4. Mix paints to create pale blue shade; paint embossed surface of die cut. Let dry completely. Sand embossed surface to remove excess paint and reveal debossed image. Adhere to Lacey Circles shape. Adhere die cuts to clay disc.
  • 5. Use pliers to open one jump ring. Insert ends of ring through hole in disc and center link of chain; close ring.
  • 6. Thread beads onto two head pins as follows: 2mm crystal; pearl; 6mm blue; 6mm blue. Create small loop at top of pin using round-nosed pliers; trim excess with wire snips. Open loops and place on chain, eight links from center.
  • 7. Use two jump rings to attach each half of clasp to chain ends.