SilveRose Mystery Necklace

Materials

  • Bright SilveRose Beadalon 7 beading wire*, 0.018” diameter
  • Crystallized elements (Swarovski): beads: Crystal Golden Shadow 5000, 13; Vintage Rose 5040, 6mm, 14; Bronze Pearls 5000, 6mm, 15
  • Silver findings*: Small Ball Head Pins, 21; Jump Rings, 4mm, four; Wire Guardian, six; Oval Scrimp, six; Toggle Clasp

Tools

  • Pliers: Round-Nose; Chain-Nose
  • Wire Nipper
  • Miniature Screwdriver

Directions

STEP 1

  • Attach one jump ring to toggle ring. Attach three jump rings together to form a chain and attach one end to toggle bar.

STEP 2

  • Cut 18” length from SilveRose Beadalon.

STEP 3

  • Loosen the screw on a Scrip finding and pass one wire end through Scrimp, Wire Guardian Jump Ring, and aback through Scrimp finding. Tighten the screw.

STEP 4

  • Leave 2-1/2” and pass the wire through a vintage rose crystal. Wrap the wire around the crystal and pass it through the crystal again to form a small loop outside the crystal. Repeat this pattern, attaching six total vintage rose crystals evenly spaced across the necklace.

STEP 5

  • Repeat Step 3 to attach wire end to second half of clasp.

STEP 6

  • Pass a head pin through a crystal golden shadow bead and make a basic loop to attach it to one of the vintage rose wire loops. Repeat for each vintage rose wire loop.

STEP 7

  • Cut 19” length from SilveRose Beadalon.

STEP 8

  • Repeat Step 3 to attach wire end to clasp.

STEP 9

  • Leave 1-1/2” and pass wire through a pearl. Wrap wire around the pearl and pass it through the pearl again to form a small loop outside the pearl. Repeat this pattern, attaching eight total pearls evenly spaced across the necklace.

STEP 10

  • Repeat Step 3 to attach wire end to second half of clasp.

STEP 11

  • Pass a head pin through a vintage rose crystal and make a basic loop to attach it to one of the pearl wire loops. Repeat for every pearl wire loop.

STEP 12

  • Cut 20” length from SilveRose Beadalon.

STEP 13

  • Repeat Step 3 to attach wire end to clasp.

STEP 14

  • Leave 2-1/2” and pass wire through a crystal. Wrap wire around the bead and pass it through the bead again to form a small loop outside the pearl. Repeat this pattern, attaching seven total beads evenly spaced across the necklace.

STEP 15

  • Repeat Step 3 to attach wire end to second half of clasp.

STEP 16

  • Pass a head pin through a pearl and make a basic loop to attach it to one of the crystal golden shadow bead wire loops. Repeat for each crystal golden shadow bead loop.
by Katie Hacker for Beadalon
SilveRose Mystery Necklace
SilveRose Mystery Necklace