Wish Big Card

Materials

  • Cardstock: Textured teal; Strathmore 110-pound Vellum; Michaels Recollections White, Light Purple, Dark Purple
  • Scrap paper

Tools

  • Provo Craft Cuttlebug Die-Cutting System
  • Cheery Lynn Designs Nautical Wheeler Doily Die
  • Fiskars Seal of Approval Large Squeeze Punch
  • Darice Multi-Purpose Heat Tool
  • Sentiment stamp of choice
  • Ink Pads: Ranger Tim Holtz Distress Dusty Concord, Broken China; Tsukineko VersaMark
  • Stampendous! White Embossing Powder
  • Adhesives: Scor-Pal Scor-Tape, Scrapbook Adhesives by 3L 3-D Foam Squares, spray adhesive

Basic Supplies

paper trimmer, scissors, ruler, pencil, wax paper (to cover work surface)

Directions

Size

  • 1. Size is 4-1/4”x5-1/2”.

Wish Big Card

  • 1. Make 4-1/4”x5-1/2” side-fold card from Vellum cardstock.
  • 2. Cut slightly smaller Light Purple and Dark Purple cardstock panels; adhere to card front.
  • 3. Cut slightly smaller White cardstock panel. Use scrap paper to mask off 1/2” section of panel; ink exposed strip Dusty Concord. Mask second 1/2” section to left of first; ink strip Broken China. Adhere panel to card.
  • 4. On White cardstock scrap, repeat masking and inking. Let dry. Punch scalloped circle from inked cardstock. Stamp sentiment using VersaMark ink; heat emboss with white powder. Adhere circle to card with foam squares.
  • 5. Die cut two doilies from teal cardstock. Determine placement of base doily on card as shown; trim as needed so doily fits on White cardstock panel. Working over wax paper, spray back of cut doily with adhesive; adhere outer decorative edge and doily center to card.
  • 6. Trim, align, and adhere outer decorative edge of second doily over base doily using small sections of foam squares.

Tip

  • 1. Save cut-out center section from second doily die cut to decorate another card.
by Penny Ward
Wish Big Card
Wish Big Card