Barn Board Sam

Materials

  • Barn board or wooden surface, 1” thick, 5-1/2”x36”
  • Plywood, 1/4” thick, 7”x11”
  • Rusty wire
  • Wooden stars: 3/4”, four; 1-1/4”, two

Tools

  • Power jig saw with narrow blade
  • Drill with small bit
  • Paintbrushes: flat, 3/4”, 1/2”; round, #2
  • DecoArt Americana Acrylic Paints: Rookwood Red, Lamp Black, Warm White, Deep Midnight Blue, Flesh Tone
  • DecoArt: Oak Gel Stain, Multi-Purpose Sealer
  • Wood glue

Basic Supplies

pencil, stylus, transfer paper, sponge brush, old rag, ruler, sandpaper, newspaper (to cover work surface), double-sided tape

Directions

Size

  • 1. Size is 5-1/2"x36"

Uncle Sam

  • 1. Sand rough edges of barn board. Apply multi-purpose sealer. Let dry; sand again.
  • 2. Print out patterns onto copy paper. Transfer mustache and hat band onto plywood; cut out using jig saw. Transfer main/body pattern onto barn board.
  • 3. On covered work surface, paint stripes on hat and trousers Rookwood Red using 3/4” flat. Let dry.
  • 4. Paint mustache, beard, stripes on hat and trousers, and stars Warm White using 3/4” flat. Let dry.
  • 5. Paint coat and hat band Deep Midnight Blue using 3/4” flat. Let dry. Repeat painting until opaque. Let dry.
  • 6. Paint face Flesh Tone using 1/2” flat. Paint eyes Lamp Black using round. Let dry.
  • 7. Adhere 3/4” stars on hat band and 1-1/4” stars (buttons) on coat using wood glue. Let dry thoroughly.
  • 8. Apply Oak Gel Stain on all areas using sponge brush. Let sit several minutes; wipe off stain using old rag. Repeat if necessary.
  • 9. To hang, drill holes at both corners of hat; insert wire and curl ends.

Tip

  • 1. Apply double-sided tape onto back of stars and press on newspaper to aid in painting sides.
by Darlene Scott

Patterns

http://dd4t7shsv7606.cloudfront.net/patterns/3245/1c8d58e3-530b-41e3-8cec-553ce21b628d.pdf



Barn Board Sam
Barn Board Sam