Farmhouse Chic Table Runner

Materials

  • Fabrics: assorted calico prints (backing), 1/2 yd.; striped (triangles), 1/2 yd.; assorted print scraps, seven
  • Light tan 14-count Aida cloth, 6” squares, three
  • Embroidery floss (Anchor): Juniper Med.Lt. (215); Topaz Med. Lt. (306); Tawney Med, (901); Amberglow (1003); Citrus Med. Lt. (302); Turf Green (683); Wheat Dk. (944); Apricot Vy. Dk. (1004)
  • Poly-fil Brand Low-Loft Batting (Fairfield), 17”x41”
  • Optional: Bone rings (hangers), two

Tools

  • Tapestry needles, size 26
  • Cream Cotton Machine Quilting Thread (Coats)
  • Sewing machine and matching thread
  • Straight pins
  • Sewing needles
  • Disappearing ink pen
  • Iron and pressing board

Basic Supplies

scissors

Directions

STEP 1

  • Following the charts, cross-stitch one leaf design in center of each piece of Aida cloth. Trim each piece to a 3-1/2” square with design centered.

STEP 2

  • Print out pattern. Cut fabrics as follows: use patterns to cut triangles from striped fabric, cut 17”x41” rectangle for backing and three 3-1/2” squares each from backing fabric and remaining seven fabrics (total 24). Use fabric marker and ruler to transfer stitching lines on triangles.

STEP 3

  • Refer to sample for suggested layout options and assemble top as diagrammed.

STEP 4

  • Place backing fabric right side down. Center and layer batting over backing. Center and layer pieced top (right side up) over the batting. Baste the layers together using a large diagonal stitch (this will be removed later).

STEP 5

  • Working from center toward the edges, machine quilt along the lines marked on the triangles.

STEP 6

  • Machine stitch 1/4” away from the center (cross-stitched) square and 1/4” from the edge of the patchwork square.

STEP 7

  • Trim batting to the size of the pieced top. Measure and mark the backing to be 1” larger than the top on all sides.

STEP 8

  • Bring the edges of the backing toward the top, folding under the edges and mitering the corners to create a border approximately 3/8”-wide. Blind stitch in place to secure.

STEP 9

  • Remove the basting stitches and lightly press. Sew small bone rings at top of back to hang, if desired.

Note

  • 1. All seams are 1/4” and are stitched with right sides facing, unless otherwise noted. Separate the floss and use two strands to cross-stitch and one strand to outline.
by Barbara Greve

Patterns

http://dd4t7shsv7606.cloudfront.net/patterns/255/18315f97-7289-40ba-a2bd-e622abb7085f.pdf



http://dd4t7shsv7606.cloudfront.net/patterns/255/cd3e8171-2332-4dd9-b8a8-2c550e507365.pdf



Farmhouse Chic Table Runner
Farmhouse Chic Table Runner Layout Chart
Layout Chart