Witch Hat Wall Art

By  Patty Schaffer  for  Dow

size: 8"x10"

  • Witch Hat Wall Art


  • Dow STYROFOAM Brand Foam Cone, 3”x6”
  • Black frame, 8”x10”
  • BasicGrey Eerie Collection Papers: Creepy, Evil Eye
  • Cardboard
  • Oval metal charm, 3/4”x1-1/4”
  • Plastic spider
  • Black crushed panné fabric, 1/2 yd.
  • Black feather boa trim, 1/3 yd.
  • Purple ribbon, 5/8”-wide, 1/6 yd.


  • Compass or circle template, 6”
  • Crystal glitter glue
  • Purple glitter
  • Adhesives: permanent adhesive runner, clear dots, low-temp glue gun

Basic Supplies

  • paper trimmer, scissors, ruler, pencil, newspapers, serrated knife, straight pins, small paintbrush
  • 1. Disassemble frame. Cut 8"x10" Creepy paper panel; adhere to glass front using adhesive runner. Reassemble frame.
  • 2. Use serrated knife to cut cone in half vertically. Cut 15" square from black fabric. Place one half-cone near side/corner of fabric. Wrap fabric around cone, securing with pins at back. Trim excess fabric, leaving small amount at top to make bent tip.
  • 3. Cut 6" cardboard circle; cut circle in half for hat brim. Wrap black fabric around brim, gluing edges to straight cardboard edge. Adhere brim to hat, making sure flat edges are flush and centered.
  • 4. Adhere boa trim around brim; adhere ribbon around hat crown, adding charm to band. Pin ribbon ends at back of hat.
  • 5. Hand-cut 6" feather from Evil Eye paper; snip edges to create fringe. Cut thin strip from same paper; roll and flatten to create center quill and adhere to feather. Tuck and glue feather into hatband.
  • 6. Use glue gun to adhere hat to frame.
  • 7. Coat plastic spider with glitter glue; sprinkle with purple glitter. Tap off excess glitter; let dry completely. Adhere spider to hat using glue gun.
  • Tip
  • 1. Create a large three-dimensional hat as a fashionable table centerpiece, or create small hats as take-home party favors.