Elegant Snowflake Stocking

By  Candice Case 

  • Elegant Snowflake Stocking


  • Red velvet, 1/2 yd.
  • Lining fabric, 1/2 yd.
  • White faux fur, 4”x16”
  • White satin ribbon, 1/8”-wide, 6’
  • Round pearls: 8mm; 6mm, four; 4mm, 16


  • Needles: chenille; beading
  • Sewing machine and white thread
  • Iron and pressing board

Pattern - Elegant Snowflake Stocking

  • 1. Print and cut out pattern. Fold fabric and cut two Stocking pieces each from velvet and lining.
  • 2. Transfer snowflake pattern onto wrong side of velvet stocking front. (Note: When copying pattern, make sure marks do not transfer onto white ribbon as it is pulled through fabric.)
  • 3. Cut four 16" lengths from ribbon. Following template, use chenille needle to embroider snowflake, making sure ribbon is flat on front of stocking.
  • 4. Attach large pearl in center and medium and small pearls as indicated on template.
  • 5. With right sides together, sew front and back stocking pieces together, using a 1/2" seam allowance and leaving top edges open. Trim seams. Repeat with lining, using a 5/8" seam allowance. Turn velvet stocking right side out.
  • 6. Fold right sides of fur together, and sew 1/2" seam on short end forming a tube. Place tub in stocking so wrong sides overlap by 3/4". Sew 3/8" from edge of stocking.
  • 7. With stocking lining, iron 1/2" to wrong side along top. Keeping fur in place, insert lining in stocking so wrong sides are together matching side seams. Cut a 5" ribbon length and fold in half. Insert cut ribbon ends 1/2" between lining and fur on heel side of stocking for hanger. Top stitch lining onto stocking. Fold fur cuff down.