Spring's Blooms Calla Lily Bucket
- Rusted pouch available through Margaret Wilson
- DecoArt Americana Acrylics: Black Green, French Vanilla, Hauser Dark Green, Hauser Light Green, Hauser Medium Green, Honey Brown, Light Buttermilk, Payne's Grey, Snow White, Yellow Ochre
- Royal & Langnickel Majestic brushes: Glaze/Wash, Series R4700, 1"; Shader, Series R4150, #8 #14; Filbert, Series R4170, #4; Liner, Series R4585, #1
- Krylon: Matte Varnish; 14kt Gold Leaf Pen
- 1. Use damp cloth to wipe pouch. Spray with varnish. Base entire outer surface of pocket Black Green. Tape off 1/2" border along top and bottom of pouch; base Hauser Dk. Green. Use #14 shader and thinned Lt. Buttermilk to add checks on top and bottom borders. Remove tape.
- 2. Print out pattern; transfer basic pattern lines onto surface. (Transfer details as needed.)
- 3. Base all leaves and stems Hauser Med. Green and lilies Lt. Buttermilk.
- Painting Instructions
- 1. Refer to worksheet and use pattern as guide to shade (///) and highlight (xxx).
- Leaves and Stems
- 1. Use Hauser Dk. Green to shade along stem end of each leaf; float down leaf center, then leaving a thin space float down center again. (Note: Space between floats is main vein.) Use #8 shader to float secondary veins. Float Hauser Dk. Green on leaves around lilies and to define flips on leaves. (see photos)
- 2. Float Hauser Dk. Green along left side of each stem and where stem connects to lily; place a float any place one stem or leaf overlaps another. Use Black Green to deepen shading where stem or leaf is behind another stem, leaf or lily.
- 3. Use Hauser Lt. Green to highlight along right side of each leaf. Dry brush highlights on bottom leaf and on far left leaf with flip. Use same color to float highlight along right side of stems and along edges of leaf flips. Brighten highlight where one stem lies over another.
- 4. Use liner and Lt. Buttermilk to dot leaves.
- 1. Float very very sheer Payne's Grey shading along inside of each lily avoiding inside top (refer to pattern). Use same color to shade where petals overlap; shade bottom right of three "whole" lilies then shade along left side of bud and remaining lily. For top whole lily, float Payne's Grey under outer petal to establish curve. (see photos)
- 2. Use Snow White to highlight inside top edges of lilies. Use liner and same color to brighten around edges of top lily and along curves of top edges of remaining lilies.
- 3. Use Yellow Ochre to add very sheer float along bottom of each lily; dry brush a light touch on inside of each lily. Use Honey Brown to deepen shading along bottom of lilies keeping float much smaller.
- Flower Centers
- 1. Base centers Yellow Ochre; shade Honey Brown along bottom and left side. Use French Vanilla to highlight along right side being careful not to go into shading. Use liner and Snow White to tap in highlights on top right.
- 1. Use wash of Honey Brown or Yellow Ochre to tint leaf edges here and there.
- 1. Use gold leafing pen to paint trim along top and bottom edges of pouch.
- 2. Apply several sealer coats over entire surface.
by Margaret Wilson