French Chic Soldered Ornament


size: 4" tall

Materials

  • Soldering glass, 1”x2”, two
  • Clear chandelier crystal, 1-1/2” long
  • French Script paper (7gypsies)
  • Watch Book Impress-ons (Marah Johnson): Christmas Designs
  • Red wire-edge ribbon, 3/4”, 14” length
  • White tissue paper
  • Silver jump rings, 5mm, three
  • Silver wire, 24-gauge

Tools

  • Damask clear stamp (Technique Tuesday)
  • Ink pads: Tim Holtz Distress Ink (Ranger): Tea Dye; Adirondack Ink (Ranger): Cranberry; StazOn (Tsukineko): Black
  • Adirondack Ink Blending Solution (Ranger)
  • Ink Applicator Tool and Felt Pad (Ranger)
  • Designer For Her Creative Soldering Tool (Walnut Hollow)
  • Black Back Copper Foil Tape (Venture Tape), 3/8”-wide
  • Tools: Wire cutter; flat-nose pliers
  • Matte Mod Podge (Plaid)
  • Diamond Glaze adhesive (Plaid)
  • Flux remover
  • Emery board
  • Terra cotta pot foot, 1-1/2”x3-1/2”
  • Rubber band, 1/4”x7”

Directions

  • Note
  • 1. Let ink dry between colors, steps and coats.
  • Ornament
  • 1. Cut piece of tissue paper to fit over top of crystal with an additional 1/2” hanging over sides. Apply Cranberry ink here and there over applicator tool pad and thin with blending solution on pad. Working on paper palette, crinkle tissue paper and stamp over it with inked applicator tool. Flatten inked tissue paper on paper palette and use Black ink to stamp damask image over it.
  • 2. Découpage tissue paper to front of crystal. Let dry and sand tissue paper around edges of crystal front. Apply another coat of Mod Podge, then apply a coat of Diamond Glaze. When dry, use piercing tool to poke hole in top of crystal.
  • 3. Cut 7/8”x1-7/8” rectangle from French Script paper. Add a little blending solution to ink remaining on paper palette from previous steps. While wet, dab script paper piece through ink to stain. Apply Tea Dye ink here and there. Apply rub-on greeting to front of piece.
  • 4. Wrap copper tape around two glass pieces with paper rectangle sandwiched between. Follow soldering tool manufacturer’s instructions to solder sides.
  • 5. Hold piece with jig to solder hump rings as shown. Thread wire through crystal and form loop at top. Bring loop through bottom jump ring on soldered piece; twist ends to secure. Trim ends. Tie ribbon ends to top rings of soldering piece. Trim ends.
  • ornament
  • 1. Make a simple jig to help as a third hand to hold pieces while soldering. Wrap rubber band twice around wide end of longest protrusion on terra cotta foot. Insert piece between rubber band and foot to hold stationery while working.

by Barbara Greve

Print Project