Butterfly Kisses Stepping Stone
Stepping stones make great gifts for friends and family - create this butterfly stone today!
- Stepping stone, 10” diameter
- Americana Acrylics: Arbor Green, Black Forest Green, Black, Deep Teal, Light French Blue, Spice Pink White, Winter Blue, Yellow Ochre (DecoArt)
- Robert Simmons Expressions Brushes: Flat Shader, Series E60, #4, #8, #12; Flat Wash/Glaze, Series E55, 1”; Deerfoot, Series E79, 1/4”, 3/8”; Liner, Series E51, 18/0, 10/0, #1; Pointed Round, Series E85, #4; Oval Mop, Series E52; Chisel Blender, Series E60, #8 (Daler-Rowney)
- Palette knife
- Sea sponge
- All Purpose Sealer (DecoArt)
- Exterior Varnish (DecoArt)
- Sta-Wet Palette (Masterson)
- Graphite: white, gray
- Wax palette
- 1. Seal top and sides of stone only. Let dry overnight.
- 2. Basecoat top and sides Arbor Green.
- 3. Pour a small puddle of Deep Tea onto wax palette and spread out thinly with palette knife. Gently press dampened, but almost dry, sea sponge into paint and pounce onto stone keeping light and airy. Rinse sponge. In same manner, pounce Spice Pink on center.
- Leaves Painting Instructions
- 1. Trace pattern; transfer onto center of stone omitting butterfly details.
- 2. Float Deep Tea around outer edges of butterfly shape, along leaf edges, and center veins. Use mop brush to soften edges along water side of float. Use Black Forest Green to deepen darker crevices and corners.
- 3. Use deerfoot to dry brush Spice Pink highlight on each leaf; add a touch of White
- 4. Use liner and thinned Deep Tea to pull veins from center. Add smaller Spice Pink lines over veins and even smaller White lines.
- Butterfly Painting Instructions
- 1. Basecoat with mix of Black + Deep Midnight Blue (3:1). Use 3/8” deerfoot to dry brush Lt. French Blue away from wing edges.
- 2. Use white graphite to trace details. With paint side of brush facing outer edges of wings, float short Yellow Ochre and Winter Blue markings as shown.
- 3. Use white graphite to trace details. With paint side of brush facing outer edges of wings, float short Yellow Ochre and Winter Blue markings as shown.
- 4. Use liner thinned with White to add tiny comma strokes along wing edges; highlight top of wings. Add Black lines between markings, pulling from outer edge to center letting line fade to a sharp point. Use Black to float base of each wing where it connects to body.
- 5. Float Lt. French Blue along outer edges of body. Use chisel blender to dry brush Winter Blue highlight on bottom section of body.
- 6. Use smaller liner and White to add head markings. Line antennae Black; add White highlight. For antennae shadow, use thinned Deep Teal.
by Sue Beckerton