Cut 15”x13” panel and 15"x3" panel from calico for backing. Cut two 15”x3-1/2” strips and two 10”x3-1/2” strips from calico for pillow front. (Not two 15”x13” panels from calico for backing)
Cast on 29 sts.; Row 1: K1, P1, rep for 6 more sts, then K for 12 sts, K1, P1, rep for 7 more sts. (not 17 more sts.)
Replace 1st sentence in Step 3 with: Squeeze burnt sienna and burnt umber on palette; dot center seed pod in spiral pattern, alternating colors, creating three-dimensional look.
Page 54: The gardenia die was misidentified. The Gardenia Strip Die (B339) is from Cheery Lynn Designs, www.cheerylynndesigns.com.
The cast-on number should be 136 stitches, not 116. Row 7 should be K4. This stole is created using five balls of yarn, not two.
With D, pick up 12 sts evenly spaced across top of First Square, then cast on 12 sts.
Rep First Square instructions from Row 1 - end.
Slovy Sticky Fabri-Solvy was used in the project, not Sulky Solvy Water Soluble Stabilizer
Revise Steps #3 and #4 as follows:
3. For the two loops: cut two strips that measure 3-1/2"-wide x 12" long from the yellow print fabric. Fold each strip in half, with right sides together; pin as needed. Stitch 1/4" in from the seam. Turn sewn strips right sides out, press with iron.
4. For the strap, cut one strip out of the yellow print fabric that measures 3-1/2"-wide x 21" long. Fold strip in half with right sides together; pin as needed. Stitch 1/4" in from the seam. Turn sewn strips right sides out, press with iron.